-
3D Printer Controller Board RAMPS 1.4 Arduino Mega Shield RepRap Prusa Model
- 3D Printer Parts, Motors and Drivers
- ₹349.00 (inc. GST)
- Supply Voltage: 12V Standard interfaces (as that of the extruder) Reserved GCI like I2C and RS232 3 MOSFET’s are applied to the heater/ fan and thermistor circuit. Another 5A added to protect the component parts. An 11A fuse is added to the hotbed. Support 5 stepper drive board
- Add to cart
-
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
- Voltage Regulator Modules, Motors and Drivers
- ₹419.00 (inc. GST)
- Adjustable frequency PWM up to about 1.6 KHz 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate Configurable push-pull or an open-drain output The output enable pin to quickly disable all the outputs Terminal block for power input Reverse polarity protection on the terminal block input Green power-good LED
- Add to cart
